Whenever I set the scale ratio, it doesn't measure using what I entered, it rounds up. For instance, I enter .125 inches but it rounds to .13. It also happens when I enter other inch ratios too. The measuring is then just an estimate measurement not true to the scale. I'm trying to measure in feet. How do I stop that rounding from happening? Rounding throws measuring and dimensions off, I would like to measure using the scale I enter not the rounded dimension. Would someone know how to do it? Thanks.
I cannot believe that this is still a concern, after all this time. If you round a scale, the scale doesn't work! Why has no one fixed this? How is it remotely acceptable?
Maybe nobody reported it. However, the original post seemed to mix up rounding and estimating. All numeric work is rounded off to some limit. Perhaps 0.001 inches is considered a reasonable point to round off when measuring in feet: you can't accurately measure 1 in 10,000 on a monitor which has less pixels than that.