Shapes Won't Appear on Main Comp While Previewing?

[One&Done]

Hello, I have tried everything to get these sprites I made from 30 ellipses to appear within the entire project. The appear when previewed within one of my comps, but not the whole comp...even when I dragged them all out.

What should I do?

Thank you very much!

[Mylenium]

Any chance you've turned them into guide layers in the parent comps? Other than that there is nothing particular discernible in your screenshot that should cause such a behavior.

Mylenium

[nishu_kush]

Hi One&Done,

Thanks for reaching out.

A screenshot of the parant comp with the modified properties visible (select the layer and press "U" two times in a row) would be helpful to understand what's going on.

Looking forward to your response.

Thanks,

Nishu

[One&Done · Accepted solution]

The only thing is that I did make it in another project completely. Then I imported this. This made me realize that the comp sizes were different.

Get this, it was all a matter of scaling down abit, as my sprites were around a bit larger version of my animated logo. Pressed 's', scaled it down some, and Voila! 

Thank you two for literally helping me to think outside of the box!