Why does the solid not match the track point in mocha?

[Armin28698347giih]

Why does the solid not match the track point in mocha?

[RobShultz]

The solid may be of a different resolution. You should be able to use the positon values to move the solid into place. Then the solid should behave as expected.

[Armin28698347giih]

thank you. I was doing the work in the wrong order.

[Rick Gerard · Accepted solution]

For a layer to work correctly with corner pin tracking, whether or not that tracking info comes from Mocha AE or AE's Corner Pin Tracker, the layer must be the same size as the comp.

When you corner pin track a surface in Mocha AE, you must make sure that you turn on the Surface viewer and set the corners where they need to go. I am not sure what you are tracking. Nothing is obvious in the screenshot. We also have no idea how you setup the Surfave in Mocha, and we don't know how big the blue solid is.

[Armin28698347giih]

thank you. I was doing the work in the wrong order.

[Armin28698347giih · Accepted solution]

This is the correct order of doing things.
I used to do it like this: 1, 3 and 2