Copy link to clipboard
Copied
Preferences/Preview/Show Internal Wire Frames
It was prechecked in AE, but after a fresh reinstall, it's now unchecked?
Do I need it? What is it?
Thanks,
Letty
Hi Letty,
Thanks for reaching out.
Yes, it's completely fine if you leave it On. For your curiosity, here's an article that describes all the After Effects preference: https://helpx.adobe.com/in/after-effects/using/preferences.html#preview-preferences_cs6
Hope it helps.
Thanks,
Nishu
Copy link to clipboard
Copied
It doesn't do much. If I remember correctly when you were using the Ray Traced rendering mode and you extruded a shape layer you could see the edges, but the switch does not seem to make any difference using the C4D rendering engine.
Copy link to clipboard
Copied
Mmmmmm I need a After Effecs film degree to understand that answer.. 😉
so for me.... ok to just leave it on?
Copy link to clipboard
Copied
Hi Letty,
Thanks for reaching out.
Yes, it's completely fine if you leave it On. For your curiosity, here's an article that describes all the After Effects preference: https://helpx.adobe.com/in/after-effects/using/preferences.html#preview-preferences_cs6
Hope it helps.
Thanks,
Nishu
Copy link to clipboard
Copied
Thanks, ON it is ! 🙂