Problem with my car in dimension

[Emilie278765308cgh]

Bonjour, 

J'ai un problème quand je mets un élément sur l'arrière coté passager celui ci se double, mais que sur cette partie, j'ai déja essayé d'exporter les UV mais ça ne marche pas sur cette partie du véhicule. 

Merci, 

[Ares Hovhannesyan]

Did you try to select only that part with selection tool before placing? Also please check if you have linked material for that parts?

[Ussnorway · Accepted solution]

if it doubles then the Uv map is behind the issue... making a map the same on left and right is very commom in car models

the two options are;

1. tell Dimension to remap the entire model or

2. use the magic wand to only remap one part of the model... normally its much less stress to use the wand for a small fix

but it can be a issue if the part you want to change is too small for the wand to detect

in this case scale the model up by 10 to make it much bigger, select the part with the magic-wand, give it a new material and THEN scale the model back down to its normal 1:1 size