Copy link to clipboard
Copied
Is it possible to reshape with the Direct Selection tool and constrain the handles in abstract directions, not just the standard multiples of 45?
Copy link to clipboard
Copied
Yes, you can change your constrain angle in the General Settings Preferences.
Copy link to clipboard
Copied
If you want even more control where the handle is locked into place regardless of the constarin angle, then there are third party tools available like PathScribe from Astute Graphics that has these options.
Copy link to clipboard
Copied
Thanks, I'll take a look at that.
Copy link to clipboard
Copied
The Constrain Angle setting will not affect the behaviour in that case.
You can use the genuine Scale tool while following the Uniform Smart Guide, but unfortunately the direction handles will then temporarily disappear while dragging them. Not ideal.
In some cases (Shift) using the Free Transform tool may be useful as well (while only single anchor points are selected).
Copy link to clipboard
Copied
Vysion,
You can do it in an old crude way and see everything as you go, with the following steps, Smart Guides still being your friends:
1) Direct Select the Anchor Point as in your image;
2) With the Line Segment Tool ClickDrag from the Handle into the Anchor to create a guide line;
3) Click the Scale Tool, then Alt/OptionClick the end of the guide line (to scale from there), then set the Uniform Scale suffiently high to extend the guide line;
4) Direct Select the path segment to reveal the Handle, then ClickDrag the Handle along the guide line as desired and see the path change;
5) Delete the guide line 3), or hide it if you may need to use it again.