Comment faire une intersection avec l'outil courbure ?

[Baptiste270519550nkz]

Bonjour, débutant sur Illustrator, je ne parviens pas à obtenir des intersections avec l'outil courbure pour finir sur un tracé déjà existant. Quand je survole ce tracé et que je clique, cela le sélectionne et la fonction courbure s'interrrompt. Auriez-vous la solution  ? Merci ! (ci-joint une vidéo pour montrer mon problème)

[michelew83603738]

It looks like you are trying to click exactly on the line that exists with your curvature tool and that is when it selects it. You need to cross over it to make an intersection, if I am understanding you correctly. But the curvature tool is acting correctly here, don't try to click on the line itself.

[Baptiste270519550nkz]

Hi thank you for your answer. In fact I try to finish my cruve exactly on the existing line. The the problem is that it is selecting this line and deselecting my curvature tool...

[michelew83603738]

I understand, so go beyond it. You can then use the direct select tool to fine tune where it ends afterwards. After you complete the line (extending beyond where your other line is or just before it will work also) use the direct selection tool and grab that anchor point to place it where you want on the other existing line.

[Baptiste270519550nkz]

Okay thank you for your help. I'm bit disappointed, this is not very practical 😕

[michelew83603738]

Can you use the pen tool - it will not do this.

[Baptiste270519550nkz]

I prefer the curvature tool, it is cleaner 😉