Trying to perfectly snap align a line, doesn't work.

[freshx7004799]

Hello everyone. Wondering if anyone help me with this issue.

I am trying to get the top line and the objects to line up perfectly with the bottom line when I move the top line and objects to the bottom line. My snap to point are turned on and it still doesnt work. I tried to use the aligners but they do not line the objects the correct way. 

[Ton Frederiks]

Do you have Smart Guides turned on?

[freshx7004799]

Yes

[Jacob Bugge]

freshx,

Are both Snap To Grid and Snap to Pixels off?

If either is on, Smart Guides will fail to guide you, however smart they are.

[freshx7004799]

Only snap to point is on. 

[Jacob Bugge]

Then it may be worth seeing your Smart Guides settings, freshx.

[freshx7004799]

I have tried them all, they do not work. I am wondering if there is a manual way of fixing this

[Jacob Bugge]

freshx,

There may be different reasons, inculding a corrupted document or a general corruption, but:

As I (mis)understand it, you wish to move the top line down to coincide with the bottom line, and to have the other objects retain their positions.

In this case, a crude way could be to:

1) Create a nostroke, no fill rectangle with the same width as the lines and a sufficient height to reach beyond the other objects, then place it with its centre on top of the centre of the top line; you can simply use the Transform palette with the centre Reference Point selected and give it the same X and Y values;

2) Group the rectangle with the top line and the other objects;

3) Give the Group from 2) the same X and Y values as the bottom line.

You can delete the rectangle afterwards, or just leave it for possible later use.