"Numbering and Selection Options"

[astropainter]

So, have a few first sections setup all to begin with No. 1. Set a Section Prefix for each one. All are "1" with exception of the second being "i".  Problem: In second section, when text flows to a second page, the second page is created YET the page number is "1" when it should be "ii". In looking at the Pages flyout, there is some discontinuity: for al of the four pages (sections) begining with "1", they are single pages at the right, with the last section that spans multiple pages, then dropping down below tht to be two side by side.  The second section, with the problem above, allow in the main window it has two pages, the first "i" the second with the erroneous "1", stacked vertically, the second with the "1" is not in the Pages flyout, visually it's not there.

[Barb Binder]

It's always helpful to provide a screen shot so that we can quickly grasp what you are asking. Are you numbering section heads or pages?

~Barb

[astropainter · Accepted solution]

Resolved: unchecked "start selection" from think it was the third section. In addition, one of the section prefixes was carried over somehow and reset/cleared that.