I have a problem I run into often and was wondering if there was a way to correct in LR. In shooting installations with artificial lighting during the day, once you balance for the interior lighting you get a blue cast for daylight. Is there an easy way to correct for the blue color temperature shift without affecting artwork, etc on the wall? I've attached two examples of the problem.
I used the Vibrance slider to oversaturate the blue areas on the whole photo and then I brushed over the blue areas with the Adjustment Brush and then used the Color Range mask to select just the blue areas. I then set the Global Vibrance to 0 (you can use gobal adjustments while the local adjustments are active) and adjusted the Local Temp and Saturation. I got the following. Not great but better than the original.
Thanks for your response. I guess my question was geared toward using the color range msk in the gradient or brush tool. I find it makes very little difference when I make my selection for the color. Where did you make it?