Copy link to clipboard
Copied
Hallo!
Am 27.11.24 bin ich von PC auf den Mac umgezogen. (möglicher Grund für den folgenden Fehler?)
Vor 2 Wochen fiel mir dann auf, dass alle KI-Bearbeitungen meiner gesamten Bibliothek fehlen. Ich kann jedes Bild einzeln in "Maskierungen" und "Entfernen" manuell aktualisieren. Dann ist auch alles so, wie ich es bearbeitet habe. Aber wenn ich LR neu starte ist wieder alles weg.
Wenn ich einen Teil meiner Fotos markiere und "KI-Einstellungen aktualisieren" drücke, sieht das mit dem Bearbearbeitungsbalken zwar kurz super aus, funktioniert aber leider gar nicht - es werden die manuellen Aktualisierungen sogar wieder entfernt, alles auf Anfang. Wenn ich alle (also über 1000) Fotos markieren und ihn aktualisieren lasse, dann gibt es am Ende auch eine Fehlermeldung, dass der Vorgang nicht abgeschlossen werden konnte.
Aktuellstes Update ist installiert.
Was kann ich tun? Da das manuelle Aktualisieren den gewollten Stand kurz zurückbringt, habe ich erst mal die Hoffnung, dass sich dies dauerhaft wieder herstellen lässt.
Beste Grüße
Next to your catalog (catalogname.lrcat) there is a separate 'catalogname.lrcat-data'. That is where the masks are stored. On a PC this is a folder, but on a Mac this is a 'package'. A package is also a folder, but with a special bit that tells MacOS to make it look like a file and behave like a file. Most likely that is why this went wrong when you moved from PC to Mac, and why it still goes wrong. Do the following: delete 'catalogname.lrcat-data' from your catalog folder and then start Lightro
...Copy link to clipboard
Copied
PS: und bei dem manuellen Aktualisieren ist es so, dass wenn ich ein paar Fotos aktualisiere, er hinten die vor vor letzten Fotos schon wieder vergisst und ich die erneut aktualiseren muss, während dann die letzten auch schon wieder vergisst.
Copy link to clipboard
Copied
Next to your catalog (catalogname.lrcat) there is a separate 'catalogname.lrcat-data'. That is where the masks are stored. On a PC this is a folder, but on a Mac this is a 'package'. A package is also a folder, but with a special bit that tells MacOS to make it look like a file and behave like a file. Most likely that is why this went wrong when you moved from PC to Mac, and why it still goes wrong. Do the following: delete 'catalogname.lrcat-data' from your catalog folder and then start Lightroom Classic again. All your masks will still need to be updated, but now this should work and should 'stick', because Lightroom Classic will now rebuild that package.
Copy link to clipboard
Copied
OMG. This was probably the quickest, most helpful and precise support answer, I've ever had. (in such a special case)
It worked!
thank you so much. You made my day and collected at least 47 Karma points.