Hi you guys! I use PTS2020, I creat an action to merge 3 exposures. Copy exp 1, close, paste on 3. copy 2 close, paste on 3. But when i process batch action, it's mess, not right 123. You know why and what can i do? Thank you so much!
if i literally follow the order that you described, i get 312. This is also not 123.
Thanks for your aswer! I mean when i want run action with batch process, images are mess, you can see below
Can you provide sample filenames for the 3 exposures?
This may require a script and not an action.
EDIT: Such as –
_MG_0280.CR2 = -1 EV
_MG_0281.CR2 = 0 EV
_MG_0282.CR2 = +1 EV
What order should they stack/layer in Photoshop, upwards from bottom to top?
Once you have a 3 layer file of combined exposures in the required order, then what?
Do you have an action that "does something" to the exposure stack?
Thanks for your aswer! I mean, if I run action in PTS for 3 exp, it ok, but when want run for many images with batch action , it not right, you can see captures below
I'm going to suggest scripting to bulk open alphabetically sorting images into sets of 3 and then combing them into a single layered file.
There is a generic script at this link:
The script can be edited so that no set quantity selection GUI appears and a fixed set quantity is hard-coded. An action or script based steps can be added for further processing to the image stack. A whole lot can be done with this basic script start-point, however, questions would need answering and your requirements will need to be clearly stated.
You may also wish to look into the following script as well:
I'll be try it, thank you so much🤩