I am photographer and product retoucher and my NUMBER ONE issue with retouching is getting the tiny jewellry to maintain their shine after editing. I always end up with a matte look after cleaning it up and I cannot find a way to really make them reflective 😞 Can someone please help me with some photoshop steps and guides? I work for an e-commerce company and we sell jewellery for piercings. So you can imagine how small these products are. Thankfully, I am quite well equiped and knoweldage with studio photography. However, retouching to maintain the reflective clean shine of the metal is by far the hardest challenge. I cannot find any courses on how to do this so your help is MUCH appreciated.
Before and after image of a labret in rose gold attached. Please see if you can find a way to help ❤️
Hi, check the following video hope it helps you...regards
Thanks for replying. Unfortunately this video doesn't help me (seen it before) as it's not the step by step tutorial I need to refine certain jewelry.
Which is before and after? Is "Edit-2" the before? If so, it looks pretty good. Might it be just a case of masking so as to get that detail back?
Hi there😄 edit 2 is the un edited image. Edit edit is the polished up one. Images are quite low res here unfortunately. Thank you for the compliment! Masking out will bring back the imperfections of the metal as this has been photographed with a macro lens. If you zoom in on edit 2, you can see what I mean.
Mmm...well, couldn't you layer the edited version on top and then mask out the just the diamonds so that the original diamonds just show through?
You could also use Camera Raw's tools (either Camera Raw by itself or as a filter in Photoshop; I prefer the former) to enhance the diamonds before even getting to the masking/editing stage.
Thanks once again for the tips. Apologies for not clarifying further. I need to find a way to edit the metal surrounding the stones. As you can see in the edited version, the polished metal looks so soft (and that was with a light brush and a mix if clone stamp and healing brush) and as a result it looks matte and not very metal like.
Definitely try what didier suggested. Could also use a Curves or Levels adjustment layer and use its mask to isolate only the metal. For example (a simple "pulling the curve down" move):
Curves (my choice) or Levels are your friend when it comes to bringing things back.
For a speed work you could use black and white points with curves or levels. It should reequilibrate the image, suppress color dominants…
Some time time ago I did a video (in french sorry) to show how it works. Not on jewelry but the principle is the same : https://youtu.be/eKEvq5O1kpc