Copy link to clipboard
Copied
Hi community.
Why does the tool bar show decimal numbers in the tool bar, but the info panel numbers X and Y location is squared off? is there a way to make the toolbar square off these numbers? without manually deleting the decimal numbers.
Thank you.
When the transform is active, the info panel reports the upper-left value in the current ruler units, while your screenshot of the transform has the middle-centre anchor point active and this may or may not be set to a matching unit of measure. To get a better understanding of this, don't use a text layer, just create a pixel layer at a known size and then compare the transform anchor points for upper-left, middle-centre, lower-right etc.
Copy link to clipboard
Copied
When the transform is active, the info panel reports the upper-left value in the current ruler units, while your screenshot of the transform has the middle-centre anchor point active and this may or may not be set to a matching unit of measure. To get a better understanding of this, don't use a text layer, just create a pixel layer at a known size and then compare the transform anchor points for upper-left, middle-centre, lower-right etc.
Copy link to clipboard
Copied
Thank you.
Copy link to clipboard
Copied
Thank you.
By @Stefan Cargoski
You're welcome!