I have a 32 second video clip on which I'd like to superimpose an image. I've successfully added the image (a PSD file) in a new layer via the Essential Graphics panel. Despite the fact that I've set the image duration as 15 seconds, it stays on screen for only about 5 seconds. I have it set to appear at 17 seconds and I'd like it to remain on screen until the end of the clip. I can't figure out how to change the duration in the Effects Control panel. Can anyone help?
not sure I understand...but what I imagine is you have a video clip on v1 and a still image on v2 and you want v2 to equal duration of v1. put the cti at end of v1 and with 'snap on' drag the still image to the cti.
My thanks to both Peru Bob and Yanna26705213grl5 for their rapid responses! I was working with all of my sequences stacked and, when working in a particular sequence, it wasn't fully expanded...thus the image I'd added wasn't visible in the timeline. When I realized I could expand each sequence vertically, it immediately became visible and I just dragged the edge to the end of the clip. (Obviously still a bit of a newbie). Thanks again.
3
Replies
AdChoices