Multicam Clip Uneditable when opening in Timeline in Premiere Pro 24

[Brett32837851yf7v]

I just updated to Premiere Pro 24 to test out the timeline improvements. However, when I create a new mutlicam sequence, I can't adjust any video or audio on the tracks to line up the sync when something is off.

Did a setting get added that locks a multicam clip when it is opened in timeline? I tried overwriting from the source monitor, but that is blocked too.

Not an issue I've run into in any previous versions with the exact same workflow.

[Brett32837851yf7v]

After diving in deeper, it's not a Premiere version 24 issue after trying on previous versions. I've isolated it to one camera roll from a Canon EOS C70 that locks a timeline from being used until I close the gap between clips.

Once I close the gap, I can then interact with the timeline normally. Transcoding did not help.