Hello, if I want to change the duration of my image i cannot choose the values between 00:24 and 01:00
if for example I choose 00:30 automaticly it will be changed to 00:24 !! what can I do to solve this problem.
Is there a clip to the right of the image on your timeline that is stopping it from expanding to 00:30. If you are using Clip Duration to do this then make sure the "Ripple Edit, Shifting Trailing Clips" is checked.
No I don't have this problem, please check the picture below to understand my problem. thank you
Is it a 24fps sequence?
Hmmm, I was assuming he was talking about seconds. But perhaps he is saying frames and could be a clue.
yes, but I not have the problem with the fps , I have a problem with the duration of the image, I can't set half of a second for my image for example, please take a look of the picture below to understand
It looks like you might be talking timecode on the sequence? If so, if it's a 24fps sequence, then timecode goes to 1:00 at 25 frames of sequence ... as the time code is:
Thank you for your response but I didin't understand you well, effectively I have a problem with the duration of my clip/image , I can't for example make the duration at a half of a second for example ( please see the image below to understand )
Can you post a video of what you are trying to do?
Your sequence is 25 Frames Per Second.
Half a second would be 12 1/2 frames. You can't have a half frame.
If it were audio, you could change the timecode to audio units and you could then trim the audio in finer units.
Thank you very much