Render Fails at any Warp Stabilized Footage

[OptOutside]

It doesn't matter if if my sequence or render is 4k, 1080p, or any codec, Premiere fails to render once it reaches any warp stabilized footage. The only time it doesn't fail is if the footage and render is vertical footage 1080p for social media content. I've upgraded my OS to Ventura thinking this would help the issue, but it didn't. I ended up rolling back to the latest Premiere 22 version and it hasn't helped. Any help is appreciated as this is a lengthy project and having to go and do stabilization in After Effects would be ridiculously time consuming.

I responded to another issue with the same error code, however, this seems to be a separate failure mode so am creating it's own discussion thread as I can't find anything on it.

MacBook Pro, 2021

Chip: Apple M1 Max

Memory: 64gb

macOS - Ventura 13.1

Premiere version 22.6.3 (build 2)

[R Neil Haugen]

Have you tried a straight render and replace for any Warped clips? Rather than exporting with Warp still being processed on the export?

Neil

[OptOutside]

Yes if i disable/delete the warp stabilizer on the affected clips it will render fine. Also if I delete only the first few, it will fail later on an the next clip with the effect.

[R Neil Haugen · Accepted solution]

I did NOT say disable Warp! I suggested doing a render & replace after intial anlysis, which applies the Warp effect to a new clip. Therefore the effect is processed by itself, a much simpler operation.

You need to set your R&R format/codec to something that is good Q of course, as that is now the clip on the sequence. If you are exporting say ProRes 422, and set the R&R to that, and use "smart exporting" by turning on use previews ... then that section is already ready for the export.

Neil

[OptOutside]

AH i see what you're saying. I think i read that really fast and late at night. Yes I think that is working so far! Thank you for the tip.  I will mention that after Analyzing,  and then render and replacing, for some reason  the blue banner gets embedded into the clip with "New   frames need analyzing; click Analyze" when it's clearly been analyzed and rendered. The workaround for that is in advanced under the warp stabilizer effect to hide the warning label. This step seems unnecessary but i dont know how else to get around it.

[jmanrech]

Thanks for all this info. I tried the R&R, but for whatever reason my clips are only replacing a portion of the original clip. Not sure why it's doing that? And I was getting the blue banner too after R&R, so that's a helpful tip, thank you.

[johnnyk7917700]

Came here with same issue, won't render if warp is active. Used to work fine but i haven't used it in months.  I updated to latest version. Render and replace is not the solution, i want to keep orginal on timeline. it SHOULD work.

I cleared all cache, reinstalled GPU drivers, PP did its initialzing gpu. Still won't render. It's a 9:16 sequence 25fps

Render and replace fails too, both with prores and dnxd (complains about aspect ratio)

[johnnyk7917700]

It was affecting two clips only for some reason, turned off  warp on those and exported, other clips with warp rendered fine. 

[Alexandre297609151ea4]

I'm having the same issue since yesterday. Have you solved that?

[dougepiper]

Yep me too. Just started today (or was just obvious today. I've not tried the software only solution.

[fl3a]

Rendering in "Software Only" mode worked for me. Slower, but got the job done.

[Lasse37434519igxi]

Worked for me - Thanks 🙂