Best Practices for image layout and positioning using anchored frames in Framemaker 10

[Guest]

Hi,

I'm looking for the best practices in how to layout my images in Framemaker 10 so that they translate correctly to Robohelp 9. I currently have images inside of Anchored frames that "Run into" the right side of my text. I've adjusted the size of the anchored frame so that my text flows correctly around the image. Everything looks good in Framemaker! Yeah! The problem is that when I link my Framemaker document to Robohelp, the text does not flow around my image in the same manner. On a couple of Robohelp screens the image is running into the footer. I'm wondering if I should be using tables in Framemaker in order to get the page layout that I'm looking for. Also, I went back and forth...is this a Framemaker question or is this a Robohelp question. Any assistance would be greatly appreciated.

[Guest]

I wish I could offer some advice, rather than simply adding to your question. I think there is something odd that happens with anchored frames.

I have been going through fits trying to figure out why the placement of my graphics shifts when I run them through Frame 10-to-RoboHelp 9 conversion. The placement in our books is flush left to the body text area. However, when they convert, some are flush left, some are centered, and a very few are flush right. My boss is very unhappy with me, as I have been unable to figure out why this is happening. I didn't create these files, so I don't know if it's something that goes back to how the graphics were initially imported. But I can't figure out why everything looks right in Framemaker, with the frame attached to an anchor tag, etc. but the placement goes hinky when they convert.

Any insights are appreciated. I'm wondering if it's going to come down to deleting them and recreating the graphic frame.