Update 3 gives warning project will be updated.

[angelae68007195]

I just installed Update 3 of RoboHelp (2022 Release). When I go to open my project, I'm getting a prompt to upgrade it. Nothing I've read about Update 3 suggests that this was going to occur. Is this a valid message...that I need to upgrade my project from 2022.1.0.188, which I believe was Update 1 of RoboHelp (2022 Release), to 2022.3.93? I had already upgraded my RoboHelp Classic Project from RoboHelp 2015 to RoboHelp 2022, so was leary on proceeding since I can't find anything that says this was going to happen. I've searched the Abode Community and the internet in general and cannot find an answer to my question. Thank you!

[Peter Grainge]

It's normal and OK. Very often this occurs in updates in the same version because of underlying code changes. Nothing to worry about.

________________________________________________________
My site www.grainge.org includes many free Authoring and RoboHelp resources that may be of help.

[Peter Grainge]

I'm assuming you have seen this https://community.adobe.com/t5/robohelp-discussions/update-3-of-robohelp-2022-release-is-now-availab... and downloaded the update. I don't think you see that warning until you start running the update but better to be sure.

________________________________________________________
My site www.grainge.org includes many free Authoring and RoboHelp resources that may be of help.

[angelae68007195]

Thank you for your quick response, Peter! I greatly appreciate it!

[Peter Grainge]

@angelae68007195 I have moved your post into a new thread as I just realised you posted in the thread I was pointing to. That thread should have been locked.

________________________________________________________

My site www.grainge.org includes many free Authoring and RoboHelp resources that may be of help.