Copy link to clipboard
Copied
Hello guys. In some tutorials ive watched, the editors made an adjustment in the pointcurve and it automaticly adjusted the parametric curve the same way. My parametric curve doesnt do this, what can i do? Thanks
That video, published Sep 2020, is likely showing Windows LR 9.4, which has the bug Johan alluded to. If you changed the Point Curve and then switched to the Parametric Curve, the graph would still display the Point Curve; but changes made to the Parametric Curve wouldn't be displayed in the Point Curve. The bug was fixed in Windows LR 10.0.
Note that this was a bug in the display of the Parameteric Curve, not in how the actual slider settings were interpreted.
[Use the blue reply button
...Copy link to clipboard
Copied
Example tutorial?
Copy link to clipboard
Copied
https://youtu.be/FK54M2B2ZEM?t=600
Here you have it. I searched in the settings but could'nt find anything..
Copy link to clipboard
Copied
Each of the curves accessed by these four buttons is separate (Parametric Curve, Point Curve, Red Channel, Green Channel, Blue Channel):
Adjusting one doesn't affect the other. If you've read or watched something to the contrary, please post a link.
[Use the blue reply button under the first post to ensure replies sort properly.]
Copy link to clipboard
Copied
Copy link to clipboard
Copied
IIRC, there is a difference between Mac and Windows here. I don't recall the exact details, but I do remember a thread (here or in the feedback forum) that discussed the fact that on Windows changing one curve does affect the other and on Mac it doesn't. I'm also not sure if that was limited to a certain version, because that is not how it's supposed to be so it could be a bug.
Copy link to clipboard
Copied
That video, published Sep 2020, is likely showing Windows LR 9.4, which has the bug Johan alluded to. If you changed the Point Curve and then switched to the Parametric Curve, the graph would still display the Point Curve; but changes made to the Parametric Curve wouldn't be displayed in the Point Curve. The bug was fixed in Windows LR 10.0.
Note that this was a bug in the display of the Parameteric Curve, not in how the actual slider settings were interpreted.
[Use the blue reply button under the first post to ensure replies sort properly.]
Copy link to clipboard
Copied
Thank you a lot!
You saved me a lot of time!