Media Encoder Beta Some object masks are offline and are therefore ignored.

[enfrl_5306]

I’m currently using Premiere Pro Beta v26.0 along with Media Encoder Beta v26.0.
After completing a mask operation in Premiere Pro Beta, I tried to render the project through Media Encoder Beta.

However, the following warning appeared:
“Media Encoder Beta: Some object masks are offline and are therefore ignored.”

As a result, the masked areas are not rendered properly.
When I use Premiere Pro Beta’s built-in render system, the mask exports correctly, but when I send the project to Media Encoder Beta, the mask data doesn’t transfer.

Window 10
Premiere Pro Beta v26.0
Media Encoder Beta v26.0

[James_Alexander2768]

go back into the effect controls and re track your mask 

[Webrunner Marketing]

We're having the same issue. 2 short clips with masks and animations behind them. I tried James_Alexander's recommendation and re-tracked the mask, but no success. 

Additionally, I'm trying to export the sequence directly from Premiere v26.0.0.027, and it crashes EVERY time (the window disappears).

Tested on complex sequences as well as simple sequences...

It's important to point out that exporting from the previous version v26.0.0.0?? didn't have any issues. (not sure what it was, but it was replaced by this week's update) 

[Tom Balev]

Can confirm this is still an issue in Me 26.1 (build 14) - only seems to be happening with Object Masks (e.g. pen mask works fine)

[EckiAME]

Should be resolved in the next release.

[sanfordjackson]

Object masks still not exporting in Media Encoder (beta)  26.1.1 

Seems to only work when I export direct from Premiere (Beta)