Copy link to clipboard
Copied
Hi,
I'm new to iOS and built a small iPhone app with Adobe Air.
I tried to install it through iTunes Sync but always running this error message after syncing:
"com.test.name" failed to install
How can I get a detailed error message to figure out what went wrong?
My config:
Windows
iTunes 11.1.5.5
iPhone 3Gs
iOS 6.1
Adobe Air 3.4
Flash CS 6
Copy link to clipboard
Copied
Did you double check to make sure you properly configured your certificate and provisioning profile
Copy link to clipboard
Copied
Yes, I added my UDID and created the certificates afterwards.
Is there a way to get a detailed error message? I just can't figure it out otherwise 😕
What are the most common problems?
iOS apps build with Air 3.4 are supported on iPhone 3Gs, right?
Copy link to clipboard
Copied
To submit to the App Store you will need to use either the release version of AIR 4.0, or the beta of AIR 13. Both of those have numerous fixes beyond AIR 3.4.
How did you get your UDID? Most of the apps for retrieving the UDID now give an incorrect value.
Copy link to clipboard
Copied
OK, I double checked everthing and it's still not working.
What APP ID do I need in to export inAIR, usually it's com.mytest.xy, but Apple added a random prefix "A6XNJC6Q2T" in the Dev Center for the certificates.
So should it take the APP ID com.mytest.xy or A6XNJC6Q2T.com.mytest.xy?
Copy link to clipboard
Copied
It would usually be com.companyname.appname. com.mytest.xy is technically legal, but anyone out there might use mytest, you ought to use your company name.
You don’t need to type in the A6XNJC6Q2T part.
Copy link to clipboard
Copied
So, I tried all possible combinations and none is working! Still "com.mytest.xy failed to install".
Is there a way to get a detailed error message or a way to check if the generated P12 certificate is valid?
Any tips welcome!
Copy link to clipboard
Copied
The app id that you set up in the iPhone portal has to be the one that the App Store provisioning profile is using, and it has to exactly match the app id in Flash (not counting the air prefix or those strange letter prefixes). It still seems unlikely to me that you would have created an app id in their system that didn’t include your company name.
So, check the app id you had set up in the portal, then make a new Ad Hoc Distribution provision profile that is based on that legal app id. Do an ad hoc build to test on your device. If that works go back and make an App Store provisioning profile, also based on the legal app id. Do one last build, as App Store, and using the App Store profile instead of the Ad Hoc one.
Copy link to clipboard
Copied
Have you got the provisioning file installed on your device? That seems to be common reason #1 for my clients
And Colin's right - if your UDID starts with FFF then it is not the correct one, so check that too.
Copy link to clipboard
Copied
UDID is from iTunes (click on serial number)
The provision profile states VALID on my iPhone under >Generel >Profiles
Could it be valid even if there would be something wrong with it?
Does anybody have a working P12 and provision profile I could use to test my device/app?
Copy link to clipboard
Copied
I have made 2 apps.
I made them at the same time, I created provisioning profiles at the same time. One installs, the other fails.
The only difference I can think of is that the failing one has external code while the successful app has code only in the frames.
Any ideas?