Drag and Drop issue with drop not working

[Crazy Cubs Guy]

Drag and Drop Issue - Cap 7. When "dropping" an object into its designated area, a "correct" drop of the source is not recognized and the item goes to the next adjacent drop zone. This is very frustrating. Any suggestions? Thank you!

[Lilybiri]

Are you sure that there is no overlapping area between the targets?

[Crazy Cubs Guy]

Hi! Thanks for the reply. Yes - that's an obvious one for me that I checked right away. There does not seem to be consistency between the drops on the targets - i.e. I cannot repeat the same successful action time after time. I will say the target zones are not all exactly the exact same sizes due to the source artwork.

[Lilybiri]

Did you perhaps increase the Hit Area Padding? What is the Snap behavior? Targets don't have to be the same size, but there is a need for space between them.

[Crazy Cubs Guy]

Hello: Where do Hit Area padding and Snap behavior exist under the Drag and Drop tab? This sounds like the remedy. Especially "Snap". Thank you!

[Lilybiri]

In the Drag&Drop panel, you'll have to select a target object to see those properties.

[Crazy Cubs Guy]

Hello: I selected the targets as you state, and I still do not see them. Can you screen shot this for me so I can see what you are specifically referring to? Thank you!

[Lilybiri]

Select ONE target, and in the Drag&Drop panel, on the Format tab you should see the options that I showed in the screen shot.

[Crazy Cubs Guy]

Thank you.