What is the trick to wrapping an object here?

[sonofmrsnak]

Trying to wrap a trifold brochure to a model, but it's not allowing me to fully extend to the front and back.

Looks like I'm required to break the trifold panel into at least only 2, not three panels. Not letting me move the front over any more than it is.
Any thoughts? 

[Ussnorway]

If you want to share the Dn with the image I'll have a go for you

[Ares Hovhannesyan]

You can download 3d broshure from web or stock or you can use 3 plane object that allowsto locate them in correct position

[sonofmrsnak · Accepted solution]

I'm using a 3D brochure object, the three panels are on one plane.  
I did come up with a good workaround: Just needed to increase the canvas side on the left, and that allowed the program to wrap properly. The top shoulds have worked, but didn't. The bottom worked fine.

[sonofmrsnak]

I meant canvas to the right side.

[Ussnorway]

thanks for letting us know you are sorted mate