Adding 2nd mic track in multitrack creates echo

Question

Hi,Im new here so i apologise if this is the wrong area and i also apologise if I'm missing info as im new to using auditon as wellI'm using audition to edit 2 . Wav files that were created in Garage band (attached samples) and when they are used in GB they sound fine.In  auditon they both sound fine individually, but when I add them to multitrack the first tracks end up sounding echoey and hollow while track 2 remains fine.There is spillover in each microphone where both mics are picking up each speaker, im not sure if this is a problem.  I tried using noise remover to reduce and spill over but it doesnt seem to matter?Any help would be greatly appreciated &#128578;

emmrecs · Answer

I downloaded your two files, opened them in two tracks of a multitrack session and they both played fine, no "echo" or anything else!

So, I suspect you are using a Template (perhaps the notorious "Podcast" one) which comes pre-loaded with certain "effects" on at least one track. If so, try starting with the Default Template (under the Template dropdown, choose "None") and check your files again! Just to add: it is the general suggestion here that possibly the very worst thing you can do to your audio is to use the Podcast Template!

I'm sure other users will post with advice about the mic "spill" though I have to say, in the short sequences you posted, it doesn't seem to me to be too bad! Some degree of gating may well help but Noise Remover is almost certainly not helpful!

HTH

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded