Aud CC will not export mix of tracks 1 and 2

Forum|Forum|9 years ago
April 10, 2017
1 reply
262 views

But I can hear them play in the session . . .

Thanks

This topic has been closed for replies.

ryclark

Participating Frequently

Where are the Track outputs routed to? In order to be mixed down they need to go via the Master output, not directly to your audio interface output channels.

M

mbyAuthor

Participant

Thanks for the fast response! It turned out I was in a different Multitrack mode where I could listen and edit, but that mode had no real outputs ????

I initiated a 'New' multitrack session and it was fine - it had all the output controls, etc.

But while I have your attention -
is there a way to have the reverb return on its own channel, like an old school console, or PT?

Also - is there a mechanical fader interface available for Audition?

Thanks again

ryclark

Participating Frequently

To get your Reverb return to it's own channel you have to create a Bus to use as an FX send track to which you add your reverb effect.

Any Mackie or Eucon protocol enabled MIDI control unit should work to provide faders. You can use either expensive ones like the real Mackie ones or low cost ones like a Korg NanoKontrol.

Remix with Firefly Community Gallery

Thousands of free creations to fall in love with and remix in Firefly.

Explore now

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.