Clicks and buffer
I want to eliminate the persistent, tiny yet audible clicks in my Yeti Blue Pro voice recordings on Windows 10.
In my research online I found that there are several potential causes and solutions, most of which I have already addressed.
One potential solutionrelated to Audition is to increase the buffer size. An AI article says :
Go to Edit > Preferences> Audio Hardware and increase the buffer size.. A larger buffer will reduce the likelihood of clicks but may increase latency, so balance this based on your needs.
Ok. Except that there is NO buffer setting in Audition, only Latency - unless this is the buffer labelled LATENCY (just to confuse everyone). In Audacity I used to use some years ago, Buffer and Latency were two separate settings. Go figure.
Is this the actual buffer size setting? if so, I have it already set at the max 500 ms and yet the clicks continue.
Removing them is very time consuming, as the Diagnostic plugin is not very subtle changing the quality of the whole highlighted audio, so I need to remove 99% of them manually one by one., to preserve the audio quality.
Grateful for advice.
AdChoices