Skip to main content
M
maryk62761295
Participant
October 12, 2017
Answered

Help removing general white noise in background

  • October 12, 2017
  • 1 reply
  • 1302 views

http://https://drive.google.com/open?id=0Bw4DUDt71hHaSldscktRWDc2SVk

I am having trouble successfully using the noise reduction process to remove the white noise in this clip.

This entire clip is about 10s long .... If you listen long enough you will notice that the same words are repeated.

That's because the first time he says it is after me doing the noise reduction process in audition to it twice. The second time is the original file with now tweaks. It seems the only difference between the two is the edited version have a certain hollow or flanged effect to it, and it actually sounds worse.

When I did the noise reduction process. these were most likely my settings:
FFT size: 8192
Spectral decay rate: 45%
dB removed: 15 dB
Noise reduction: 65%

Though I have since experimented with them, but didn't get much better results. Noise reduction is really the only audio cleanup process I am familiar with in Audition. If you can help me make this process work, or point me in the direction of the process that will work, I'd greatly appreciate it! Thanks!

This topic has been closed for replies.
Correct answer Bob Howes

I'm afraid your link doesn't work for me--I get an error message when I click on it.

However, based on the settings you've used, I can make a suggestion.  Instead of one "big" pass of NR with the Noise Reduction slider set to 65%, try doing several (say 4) passes with the slider set to 10 or 15%.   Start with the FFT size set to 2048, then increase the FFT by one setting between each pass.  You'll need to take an new noise sample for each new FFT setting.  This will increase the amount of reduction you can get at the same time as greatly reducing the undesirable artefacts. 

I'd probably also take the dB Reduction down to around 10dB per pass.

Finally, I tend to use a Spectral Decay Rate of around 65% but this shouldn't make too big a difference.

1 reply

Bob Howes
Bob HowesCorrect answer
Inspiring
October 12, 2017

I'm afraid your link doesn't work for me--I get an error message when I click on it.

However, based on the settings you've used, I can make a suggestion.  Instead of one "big" pass of NR with the Noise Reduction slider set to 65%, try doing several (say 4) passes with the slider set to 10 or 15%.   Start with the FFT size set to 2048, then increase the FFT by one setting between each pass.  You'll need to take an new noise sample for each new FFT setting.  This will increase the amount of reduction you can get at the same time as greatly reducing the undesirable artefacts. 

I'd probably also take the dB Reduction down to around 10dB per pass.

Finally, I tend to use a Spectral Decay Rate of around 65% but this shouldn't make too big a difference.

M
maryk62761295Author
Participant
October 12, 2017

Thank you! I tried this and it helped some!

Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices