Skip to main content
February 1, 2011
Question

Can I use playback controls from Captivate 2 in Captivate 4?

  • February 1, 2011
  • 1 reply
  • 290 views

I have a series of simulations that were created using Captivate 2. I had to make a variety of edits to just one of the simulations, and I did that using Captivate 4, as I no longer have Captivate 2. (I now have Captivate 4 and 5.)

Unfortunately, when I went to publish, I discovered that the playback controls that I used in Captivate 2 are no longer available in Captivate 4. This is an issue because all the simulations are part of a large course that has instructions on using the controls.


Also, even worse, in the original course, I had placed the controls at the top middle, over the Captivate simulation. It now appears that I can only place the controls above the simulation. The simulations were sized to fit into a particular space, and this adds to the size of the simulation.

Thus, my questions are:

(1) Is there any way in Captivate 4 to place the playback bar over the simulation, as I did in the previous simulations?

(2) Is there a way to use playback controls from previous versions in Captivate 4?

    This topic has been closed for replies.

    1 reply

    adaptable_body6C19
    Participating Frequently
    February 7, 2011

    Hello,

    As per your question, i beleive that you should be able to retaun features of your rpoject from CP 2 to CP 4. However if youa re unable to do that then you can follow the guidelines below.

    Open the RoboDemo files (*.rd) in Adobe Captivate 2 and save them as *.cp files. You can then open these *.cp files in Adobe Captivate 4 or later versions.

    Also to adjust the position of playback control  in CP 4, you can go to SKIN EDITOR under PROJECT TAB and adjust it accordingly,.

    Let me know if this helps.