Skip to main content
A
Anonymous
April 19, 2013
Question

Fading in shapes and them not showing in the project?

  • April 19, 2013
  • 1 reply
  • 549 views

I am trying to fade in shapes to pop up at a certain time.  It works just fine when I preview the slide, but when I watch the presentation they do not show up?  Any advice?

    This topic has been closed for replies.

    1 reply

    B
    Brave_difference15D5
    Participant
    April 19, 2013

    I've had the same problem before.  It had to do with some custom buttons on the page that had a pause set on them.  Is this the case for you?  If so, make sure that the timing on the paused button goes the full length of the slide.  Hope that makes sense.

    If not, can you provide more details?

    A
    Anonymous
    April 19, 2013

    Where is the pause button?  I don't know that I have ever (on purpose) used it before

    Thanks

    B
    Brave_difference15D5
    Participant
    April 19, 2013

    It is a property of the timing section of the Properties panel. You could also check to see if there is some type of pause property for the entire slide by looking under the timing property, too.  Maybe that will help?

    Terms & ConditionsAccessibility statement
    Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices