I'm getting an error that the BakingProcess cannot load a high-poly model.

Question

It is as the title says. Even after baking, I get the error 【[BakingProcess] Highpoly scene was required when baking Normal Map from Mesh but could not be loaded】.

The situation is as follows
--------------------------
I have a high-poly model that I sculpted in zbrush and exported it in Goz. I created a low poly model by retopologizing the model. After that I did UV expansion of the low poly models and exported each model as FBX.

I added _low and _high to the end of each model's name.

The number of vertices in the high-poly model is 2 million. I thought the number of vertices was too high, so I tried baking the model down to about 130,000. The result was not good.

I thought that using UDIM might be a problem, so I combined the UVs together, but the results were not good.
-------

I'm having a hard time finding an answer. Does anyone know of a solution?

gen562030 · Accepted Answer

Thanks for the reply, Jeremie.I'm sorry it took me so long to get back to you due to work.This problem was caused by a trivial mistake on my part.The names of the low-poly and high-poly data did not match.It's a shameful story.Thank you Jeremie for your advice for me.If I have any more questions, I may post them in this forum. I hope you will give me warm advice again.See you soon. Have a good day.

Jeremie Noguer · Answer

2 millions triangles for a high poly mesh is on the low end side, you shouldn't have any issue.What is your GPU model? Could you share a log file please?

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.