Skip to main content
D
defaultt5104e7sgrwt
Participant
July 13, 2022
Question

Clone Stamp-new user

  • July 13, 2022
  • 2 replies
  • 310 views

Hi everyone,

I am having issues with my clone stamp tool. I am new so maybe this will be a funny question(s):

 

1. I used to be able to just "stamp" an area. Now I can only "paint" an area like a brush. Is there any way to just "stamp" instead of paint

 

2. My clone stamp "+" sign keeps moving... I want to be able to clone an area without having to redefine the same source point over and over again. I thought I was able to do this a few weeks ago but now the + keeps moving with every "brush" stroke I do. I am not talking about the alignment.  

 

What am I doing wrong? Please be patient. I am new to photoshop and I have been scowering the internet for days 😞 

This topic has been closed for replies.

2 replies

Bojan Živković11378569
Community Expert
Bojan Živković11378569Community Expert
Community Expert
July 13, 2022

Why you can not "stamp"? Click once with left mouse button and release, that should stamp, if I can understand your question correctly.

    D
    defaultt5104e7sgrwtAuthor
    Participant
    July 13, 2022

    Hi Bojan,

    For the "stamp" problem I figured out that the issue. The "Flow" option was set too low. You are correct. However the error on my end was that the Flow option was set too low. 

     

    Thank you for your help!

     

      barbara_a7746676
      Community Expert
      barbara_a7746676Community Expert
      Community Expert
      July 13, 2022

      1. You should be able to just stamp -- that is click on an area. If you can't maybe it's because you need to increase the brush size. Or maybe you need to increase the hardness. Or maybe you need to choose a different brush.

      You could start by selecting the Clone Stamp tool in the Tools panel, right clicking the icon in the Options bar, and resetting the tool.

      2. To continue to clone from the same source point, remove the checkmark from Aligned in the Options bar.

      With Aligned removed, each time you release the mouse and start cloning again, the crosshair will go back to the original sampling point.

       

        D
        defaultt5104e7sgrwtAuthor
        Participant
        July 13, 2022

        Hi Barbara,

         

        I was able to figure out why I was unable to "stamp". I had the hardness set high as well as the brush size. I realized it was due to the "Flow" option. I had that bar set very low. I am still having trouble with the source point. I have tried the "Aligned" method but that is not quite what I am looking for. Maybe I can atatche some screenshots to show you? 

        Terms & ConditionsAccessibility statement
        Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices