Wacom tablet and source point issue.

Forum|Forum|5 years ago
April 1, 2021
1 reply
319 views

I'm having a problem when i try to alt+click to change the source point for the clone stamp tool the point does not change unless i hit the pen down extremely hard onto the tablet. This is a brand new install of photoshop and Wacom drivers. What could cause me to have to hit the pen down so hard? Using the pen to click on anything else works as normal with very little pressure needed.

Problem or error

This topic has been closed for replies.

Kevin Stohlmeyer

Community Expert

Have you checked your pressure settings in your Wacom preferences?

N

NicsammetAuthor

Participant

hi! yes just to verify i put it on the most sensitive setting and nothing has changed, i got it to work temporarily but after a few minutes it started to act the same. when i say i have to hit it i mean forcefully strike down on the tablet. the pen is doing fine with pressure if i draw. so i assume i dont have a pen issue. im sure its a failure to recognise the alt click since when i initially tried to alt+click my first point it gave me the popup for no point selected

Kevin Stohlmeyer

Community Expert

Do you have the pen set to Mouse mode in the Wacom settings?

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded