What's up with the Clone Stamp Tool?

Forum|Forum|6 years ago
June 23, 2019
3 replies
902 views

Opened a new empty layer, Flow, Opacity at 100%, sample current and below. Totally unusual behavior. Where does the edge come from??? Also used a mask before, same result.

This topic has been closed for replies.

c.pfaffenbichler

Community Expert

Is a Selection active?

D Fosse

Community Expert

My thought too. A selection can be active but hidden with ctrl+H.

Semaphoric

Community Expert

Open the Brush Settings panel, and see if there's anything checked that shouldn't be.

R

Raspiratadantatay

Participant

Might it be the Aligned checkbox? I don't use that, but everything else seems like there shouldn't be an edge.

jane-e

Community Expert

Raspiratadantatay wrote
Might it be the Aligned checkbox? I don't use that, but everything else seems like there shouldn't be an edge.

Hi Raspiratadantatay,

When Aligned is checked (default), it means you can stop and start and continue on. When it is unchecked, then the painting goes back to the source point each time you stop and restart. Try it both ways if this is new to you, but no. That would not cause this issue with the edge.

~ Jane

R

Raspiratadantatay

Participant

Thank you for that info! I agree with the last couple comments that he should do a deselect all then.

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded