Adobe wont let me mix down my session?

[AaronR805]

So I'm a new to adobe audition, i've been using cool edit pro all my life but finally upgraded to windows 10 and sadly cool edit pro was not compatible, so I download adobe audition cs6, so today I recorded a new song, Its fully mixed and just needs to be mixed down to mp3, but every time I go to "multitrack-mix session to new file" the "entire session" tab is not highlighted, I did change the output from "Master" to "stereo" on all my tracks because it wasn't letting me Pan my audio left or right. Any help would be greatly appreciated!!!!

[SteveG_AudioMasters_ · Accepted solution]

aaronr805  wrote

I did change the output from "Master" to "stereo" on all my tracks because it wasn't letting me Pan my audio left or right. Any help would be greatly appreciated!!!!

Assuming that you created a stereo session in the first place... (if you didn't, then you'll have to remake your session using the correct template)

Change them all back to Master. If you don't do that, there's nothing to mix! If you set the track outputs to a physical device, then that's the only place they will go to.

[AaronR805]

As In Remake you mean delete everything and start all over with the correct template? And If I change them all back to master, all the tracks I panned left and right will all be centered and it just kills my whole song! and I recorded using my focusrite scralett 2i2 interface as an output, then I disconnected it and went to my room to mix the song and switched the audio hardware back to asio4all. could that have done it?

[SuiteSpot]

SteveG is right you need to set the output of each track to Master to get a mix

Email me your sesx file (no media required) and I will see what I can do to get the tracks set to stereo

email:  info at aatranslator dot com dot au