Can't seem to get stereo signal recorded from stereo mic

Question

Bought creative suite. Bought Blue Yeti Pro mic. Last November I recorded a smal group in stereo.
Tried two weeks ago and only got mono signal from the mic. Finger snaps on opposite sides of mic identical in bloth channels. Three weeks later I hav a nnew mic from Blue Yeti. Same problem. The Yetti is a UUSB mic it has a selector switch for capsule patttern, its in stereo mode. I have uused two cables and two different USB inputs result is the samee both sides of the stereo meter move identicly. Help please.

SteveG_AudioMasters_ · Accepted Answer

Also Audition gets a stereo signal if I pic mic array built into laptop as a record source. I just can't imagine my original Yeti miic stopped function after 1 use and the replacement I waited two weeks for has the same problem

There is one other thing you can try which will determine pretty much what is happening, and that is to try making a recording in Waveform view. If you open Waveform view without a file selected, it will prompt you to start a new one, so if you check the box and make sure it's a stereo one, you should be good to go. It will be obvious if it's making a mono file because the two meter bars will be locked together. Can you try that, please?

Richard M Knight · Answer

Can you hear 'stereo' in the headphones connected to the mic?

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded