Skip to main content
J
josephchau
Participant
October 20, 2013
Answered

how to reduce or increase bass in audio

  • October 20, 2013
  • 3 replies
  • 139383 views

Hello all

(1) what is the best way to reduce BASS in an audio (it's too loud) in adobe audition CS6/CC

(2) Also if your audio file is too low in volume including BASS, TREP etc.. how do we using

       Effect in Audtion CS6/CC to increase to its normal good hearing

your help is greatly appreciated

Best Regards

    Correct answer ryclark

    What you need for adjusting the bass frequencies is an Equaliser (EQ). There are lots of different varieties in Audition under Effects/Filter and EQ. Try experiment with Graphic Equaliser first which has sliders for easy adjustment of different frequencies.

    If you just need to boost the volume of the whole audio file you need the Amplitude and Compression effects. Amplify is the simplest.

    3 replies

    J
    JS Joy
    Participant
    December 31, 2019

    Thank you so much sir.

     

    Z
    zeket52401351
    Participating Frequently
    November 18, 2017

    Similar to what ryclark said, I go to effects > filter and EQ > parametric equalizer and to remove some of the bass I drag the "H" down and to the left, creating a wave shape rather than a straight line. Mess around with the "H" and the "L" to try to get the sound that you want.

      A
      ASCProduction
      Participant
      May 12, 2018

      how to increase volume while recording the audio is barely visible

      ryclark
      ryclark
      Participating Frequently
      May 12, 2018

      It would have been better to make this a brand new thread rather than adding it to a four year old one which was about a different problem.

      However to increase the level of the recorded audio you have to make sure that you have enough audio signal from the source. Audition only records what it is sent by the audio drivers for your audio interface. So you have to adjust the incoming levels on the interface itself or whatever is feeding audio into it.

      You can, of course, increase the volume levels afterwards in Audition. But that is then likely to show up additional problems like unwanted noise and hum etc.

        ryclark
        ryclarkCorrect answer
        Participating Frequently
        October 20, 2013

        What you need for adjusting the bass frequencies is an Equaliser (EQ). There are lots of different varieties in Audition under Effects/Filter and EQ. Try experiment with Graphic Equaliser first which has sliders for easy adjustment of different frequencies.

        If you just need to boost the volume of the whole audio file you need the Amplitude and Compression effects. Amplify is the simplest.

          Terms & ConditionsAccessibility statement
          Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices