Copy link to clipboard
Copied
A Nef file edited and saved to Jpeg yesterday was ok. Today the Nef file has red lines (diagonal due to a levelling crop). Yesterdays Jpeg and today's attached. Restarting LrC 9.3 did not help.
Copy link to clipboard
Copied
Normally this is a sign of hardware failure:
memory card going bad
problem with the card reader
USB cable broken
bad sectors on the hard drive
In this case, since the problem is new and well after being copied to the hard drive, the first suspect is a bad sector on your hard drive. Of course, a good second opinion is to try a Nikon program (View NX-i or Capture NX-d) just to verify it is not a raw interpreter problem.
Copy link to clipboard
Copied
Thank you for your response. I've since found that opening the NEF file outside Adobe it is fine. The problem only manifests in LrC and Photoshop.
Copy link to clipboard
Copied
That's because other software often shows you the JPG preview which can be uncorrupted when the RAW image itself is corrupted. So, the conclusion remains ... the only known source of this particular type of corruption is hardware.
Copy link to clipboard
Copied
Try turning off the option to use the GPU in the LrC Preferences on the Performance tab and test.
Copy link to clipboard
Copied
I've not tried that yet. Mainly because it's only affecting one image in a folder that holds 100s Thinks for the hint.
Copy link to clipboard
Copied
I'm now convinced it's a Library glitch. Red lines are not there in the Develop module or any other Raw file viewer.
Here is the same image viewed in the Library and Develop modules.
Copy link to clipboard
Copied
Then the RAW file itself is not corrupted, but the preview that is shown in the Library Module is corrupted.
What happens if you select this photo in the library module and Library->Previews->Build 1:1 Previews?
Copy link to clipboard
Copied
And when you turn OFF GPU?
Could also be a corrupted display profile. Recalibrate, build a new display profile. Might clear up. Don't make a LUT based profile if the product provides such an option, just Matrix profile, Version 2, not Version 4 profile.