Anybody use a Ugee M708 graphics tablet?

I solved all issues by installing the TEST DRIVER 2018 from ugee website ( http://ugee.net/upload/download/20180504/5aec2135bdb42.zip

My story....

I have Windows 10 and upon plugging in the tablet it worked just fine, but had no ability to configure the hot key buttons on the side of tablet or any other related features. After messing around with the other driver ( M708(8192) Driver For Win ) listed on the site which installed an app called pentablet or something... it said it "could not detect the tablet and try plugging in or uninstalling other drivers".

After just uninstalling the "pentablet" software it just installed through  " Add and Remove Programs and Features " in control panel, i just ran " Setup.exe " in the TEST DRIVER PACK i linked to up above and voila! I can run and configure the Ugee Tablet configuration software.

anyone else having an issue when the pen draws even though it is not pressed onto the tablet? it means that i can not draw properly because the pen automatically draws when it is hovering above the tablet.

I found that you have to check the "Supports Digital Ink" box on UGEE's control panel. I found this fix on YouTube and it worked for me.

I was stuck on this for a while too but i figured out that when you go to the UGEE control panel i needed to check the "Support digital art" box in the info tab, this is probably a late azz reply tho

Hi.

I restarted the laptop many times after uninstall reinstall the original cd..

but my problem was to change the pen nip!

still on Illustrator a bit instable but I ll get a new version.

With Sketchbook it is fine already

I've had the same problem. I had an old tablet installed. Solved the problem by uninstalling both tablets, rebooting the computer, then installing the Ugee-tablet. After another rebooting, e verything worked fine.

Don't know if this will solve your problem, or even if you've had an old tablet, but it's woth a try.

basically you have to remove the driver then reinstal it again.

Here is the response from support:

Please do the following:

1. Find the tablet in Control Panel- Programs - Programs and Features - PenTabletSetting.

2. You may see the little icon in your task tray, which is in the lower right corner of your computer. If not, follow step on to open tablet control panel, check Show icon in task tray.

3. Uninstall all the other tablet drivers on your computer, restart your computer and then follow the steps below:

1. Get the installation package from the disc or download from the official website. http://ugee.net/download.asp

2. Extract the tablet and unzip the installation package, find the ‘setup.exe’ driver.

3. Before installing, please make sure the tablet has connected to the computer.

4. When installing the driver, please do not change the installation directory and install the driver in C drive.

5. When you have finished the installation process, please restart the computer. Once the tablet has been distinguished, a little blue icon will show up in the lower right corner.

6. Open the driver icon, start to take the pressure test. If it is normal, then the driver has been installed correctly.