Skip to main content
G
Geoffrey Heslop
Participant
February 22, 2023
Question

Edit, Perspective Warp command fault

  • February 22, 2023
  • 1 reply
  • 635 views

When using the function Edit, Perpective Warp, after marking of the required area and then going into the Warp mode, my image immediately rotates 180 degrees and leaves the designated where it was sited. What is going wrong.

This topic has been closed for replies.

1 reply

Myra Ferguson
Community Expert
Myra FergusonCommunity Expert
Community Expert
February 23, 2023

There's a rather large thread that you might want to check out that discusses the issue:

P: Perspective Warp upside down

 

Terms & ConditionsAccessibility statement
Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices