Is Double sided Bevel with Extrude Curve node possible? Or orientation of extrusion in model graph.

Question

I am attempting to create a procedual barrel base mesh using strickly curve nodes within substance designer 3d model graph. I am adding a handle currently using extrude curve node. The only issue I am having is that the bevel only occurs on one side of extrude. Is it possible to extrude it on both sides or orient it to the other side.

As a second note, does anyone have a solution to the "Error: PreProcessFailed" when expoting to a model graph.

Thanks.

davescm · Answer

As far as I know the bevel only works on the top.

As an alternative, could you extrude an elliptical curve along a C shaped curve (partial ellipse) using a sweep curve node? That would still give you exposable parameters for the handle

On the error message, Luca (from Adobe) mentioned in a post a couple of days ago that the error can appear if a parameter's default value is out of its soft/hard range set when the parameters were exposed. It may be worth a look there.

Dave

Sign up

To post, reply, or follow discussions, please sign in with your Adobe ID.

Sign in to Adobe Community

To post, reply, or follow discussions, please sign in with your Adobe ID.

Scanning file for viruses.

This file cannot be downloaded