Creat a new clip with sequence resolution and no original resolution when i create a enhanced audio
Subject: Premiere Pro 27.0 – Enhance Speech creates a hidden nested sequence at the active sequence's resolution and crops the video
Hello Adobe Support,
I'd like to report a bug with Enhance Speech (Essential Sound) in Premiere Pro.
ENVIRONMENT
- Premiere Pro 27.0 (build 88)
- macOS, MacBook Pro with M5 Pro chip
- Media: 3840x2160 (landscape) .mov, 59.94 fps, stereo 48 kHz / 24-bit audio
- Sequence where it was applied: vertical 1080x1920, 59.94 fps, with the 4K clip reframed via Motion (Scale/Position)
STEPS TO REPRODUCE
1. Create a vertical 1080x1920 sequence and add a 3840x2160 landscape clip, reframed with Motion (e.g., Scale 130%, offset Position).
2. Select segments of that clip in the timeline and apply Enhance Speech from the Essential Sound panel.
EXPECTED
Only the audio is processed, and the video keeps showing the full 4K frame with the same reframing.
ACTUAL
- Premiere creates a nested sequence named "<file name> (Enhanced)" and replaces the timeline segments with it.
- That nested sequence is created at the active sequence's resolution (1080x1920) instead of the media's resolution (3840x2160), so the video is center-cropped. The side areas of the 4K frame are lost and the Motion reframing no longer works.
- The "(Enhanced)" sequence does not show up as a sequence in the Project panel and cannot be opened (not even by double-clicking the nested segment), so there is no way to fix its Sequence Settings through the UI.
- In another project with the same kind of media, the "(Enhanced)" sequence was created correctly at 3840x2160. The behavior seems to depend on which sequence is active when Enhance Speech is applied.
WORKAROUND
The only fix I found was via ExtendScript (sequence.getSettings() / setSettings(), setting videoFrameWidth/videoFrameHeight to 3840x2160). After that, the framing was correct in every segment.
REQUESTS
1. Create the "(Enhanced)" sequence with the source media's resolution and frame rate, not the active sequence's.
2. Allow opening/editing that sequence from the UI (at least Sequence Settings).
3. Ideally, process only the audio without replacing the video in the timeline.
I can share the project and screenshots if helpful.
Thank you.
