I found it... It is so silly!!!!!!!!! It's like when some girls call the technician to fix the TV and they have forgotten to plug it for power... But it is a question I have, though. Why can't it be done my way. When I trim the layer with Particular on, the camera does not work. If I don't trim it, the camera works. I always trim the layer in order not to wait for the effect to build up....
This is the Video Link: Trapcode Particular Camera Issue 2 - YouTube
Why is this happening?
That actually makes a little bit of sense to me. particular is based on time and you have moved the layer so far back in time that the camera is seeing what happened a few seconds earlier instead of what is happening now. If you set keyframes for the emitter at 10 seconds and then slid the timeline so the keyframes were at - two minutes you would never see the change. I think that is what is happening to the camera move.
The normal workflow to pre-run the emitter is to open up the emitter extras and set the emitter pre-run to 100%. The details are in the User Guide.
Emission Extras> Pre Run
This control is used to pre-run the system so that particles can be visible at the first frame. The pre-run value is a percentage value where 0% is no pre-run. At a value of 0, the simulation essentially starts at the first frame where no particles have been emitted. A value of 100 translates to a 100% completion of the emission of particles on the first frame. At 100%, all particles that should be emitted at the first frame will appear based on Emitter controls like Velocity and the particle life.
AdChoices