Skip to main content
Participant
October 23, 2022
Answered

Warp Stabilizer stops on random frams

  • October 23, 2022
  • 1 reply
  • 285 views

Guys, if you can help me I would greatly appreciate it. Im at a loss here.

Whenever I apply Warp Stabilizer to a clip, there are times (random) where it will stop at a random frame and will not continue to analyze. This can happen to any clip, at any time, however it is more likely to happen to longer clips since there are more frames. Whenever this happens i need to close After Effects and re-open. Simply deleting the WS effect and trying to re-apply it in the same session does not help. This is incredibly frustrating and slows down my editing process, please help.

Below is my PC setup-

I9-10900x

RTX 3060ti

64GB RAM

 

This topic has been closed for replies.
Correct answer Mylenium

This sounds like a cache issue. Perhaps the disk performance breaks down, perhaps another app is interfering, perhaps you simply run out of space. I would check these things and, though it may sound counter-intuitive, set the disk cache to the bare minimum. Also of course check stuff like multiframe rendering, hardware acceleration, preview settings and so on.

 

Mylenium 

1 reply

Mylenium
MyleniumCorrect answer
Legend
October 23, 2022

This sounds like a cache issue. Perhaps the disk performance breaks down, perhaps another app is interfering, perhaps you simply run out of space. I would check these things and, though it may sound counter-intuitive, set the disk cache to the bare minimum. Also of course check stuff like multiframe rendering, hardware acceleration, preview settings and so on.

 

Mylenium 

Participant
November 2, 2022

The SSD i use for cashe is almost completely empty, so its not that for sure. I will check the other solutions