Skip to main content
Inspiring
Oct 4, 2022 9:50 PM UTC
Answered

cannot run Bridge v 12.0.3.270 on an Apple Mac Pro

I cannot run Bridge v 12.0.3.270 on an Apple Mac Pro running Monterey OSX v12.6.  Once Open, I get the spinning wheel.  It had been working OK until recently.  I have Quit & Restarted, resetting Preferences and clearing Cache, four times.  No luck.  I have Uninstalled Bridge and downloaded & installed a fresh version of Bridge three times.  No luck.  I tried installing the previous version of Bridge (12.0.2.252).  No luck. I have run Disk Utility several times on my boot drive and even, using Apple Recovery Mode, installed a fresh copy of the OSX.  No luck. I am a working professional photographer and simply cannot function without a working version of Bridge. I have wasted hours on this.  Any suggestions sure would be welcome. Thanks.  Mark W.

This topic is closed to new replies. Start a new post to keep the conversation going.
Mark_WeidmanCorrect answer
Inspiring
Oct 5, 2022 4:11 PM UTC

Thanks for the response. Last night I finally was able to get Bridge to run again. Un-install, reboot, ran Disk Utility, reboot, re-install Bridge and it finally worked.

Mark


2 replies

Mark_WeidmanAuthorCorrect answer
Inspiring
Oct 5, 2022 4:11 PM UTC

Thanks for the response. Last night I finally was able to get Bridge to run again. Un-install, reboot, ran Disk Utility, reboot, re-install Bridge and it finally worked.

Mark


Translate
Legend
Oct 5, 2022 3:50 PM UTC

Does this happen in Safe Mode? What about with external drives disconnected? Have you given Bridge permissions for Full Disk Access?

Translate