"Drag and Drop [public library] book to NOOK"

I got the answer from "Frustrated in AZ".  I should have been dragging the library book icon in ADE to the NOOK bar on the left side of ADE and dropping it there, NOT to the NOOK on the removable device page.  I thank him for his prompt response.

What you may be misunderstanding is the way you do a 'drag and drop'. That

goes back to how the ebook reader and ADE link up, so let me go over that.

No offense intended.

You should attach your ereader to your computer (I'll assume a Windows PC)

and make sure that the PC recognizes it and gives it a drive letter. The

Nook should display information that it's connected as well. Then, start

ADE. During its startup, ADE looks for attached ereaders, and when it

finds them, it displays them on the bookshelf panel of the Library view

(the left hand side). You'll see a small entry that represents your Nook.

Then, just put your cursor on the ebook in the library, hold it down and

'drag and drop' it to the entry that represents your Nook. A couple of

screens will flash as ADE makes the transfer, and your Nook will tell you

that it's receiving the entry. Then, when you've finished dragging and

dropping ebooks to the Nook, you need to disconnect it logically from the

PC (before you shut down ADE). You can do that by using Windows Explorer

(NOT Internet Explorer): look at all of the devices attached to your

computer (including all of the drives), find the one that's your Nook, and

right click on it. Select 'Eject' from that menu. This disconnects the

Nook logically from your computer. You can use the icon on the far right

hand side of the START bar that shows 'Safely Remove Hardware' when you put

your cursor on it also. Right click on that icon and you'll see a list of

drives. Click on the drive letter that represents your Nook and it will be

disconnected.

Once the Nook is disconnected logically, its screen should show that it's

processing new content. When it stops doing that, you can unplug it and

you're done.

The loan token is a library issue, not an ADE issue. Somewhere back in

their software, the loan token is not being set. You should talk to the

library's technical support folks about that. And don't let them give you

b-s about ADE dropping it: all ADE does is to look for it in the library's

file.

Hope this helps!

======================