Skip to main content
roneekab79
roneekab79
Participant
February 3, 2018
Answered

White Border when I export to PDF

  • February 3, 2018
  • 1 reply
  • 73160 views

Hi

I have been trying to export a letter size (8.5 x 11) 2 sided document to PDF on In Design.  The projects covers the entire size and has no borders on the In design screen.

I need for the PDF to cover the entire page without any border, but no matter what I change on the Marks and Bleeds window, I keep getting a PDF document with a white border - can anyone help?

Also, I'm a total novice, so step by step would be incredibly helpful.

Thanks so much

This topic has been closed for replies.
Correct answer Bill Silbert

When you make your pdf use the Export option under the File Menu and in the resulting dialog window choose Adobe PDF (Print) from the pull-down menu in the lower part of the window. After you do that you will see the Export Adobe PDF dialog window. In there go to the Marks and Bleeds section and set it up as in the screen shot below:

You will be able to get a pdf where all of the image goes to the edges but you should know that if you try to print it full size on a piece of letter size paper you will get that margin of white at least on one side since almost all printers need about 1/4 inch of blank space for their grippers. If you need it to print to the edge you will have to do it on paper later than letter size and trim it out.

1 reply

Bill Silbert
Community Expert
Bill SilbertCommunity ExpertCorrect answer
Community Expert
February 4, 2018

When you make your pdf use the Export option under the File Menu and in the resulting dialog window choose Adobe PDF (Print) from the pull-down menu in the lower part of the window. After you do that you will see the Export Adobe PDF dialog window. In there go to the Marks and Bleeds section and set it up as in the screen shot below:

You will be able to get a pdf where all of the image goes to the edges but you should know that if you try to print it full size on a piece of letter size paper you will get that margin of white at least on one side since almost all printers need about 1/4 inch of blank space for their grippers. If you need it to print to the edge you will have to do it on paper later than letter size and trim it out.

    roneekab79
    roneekab79Author
    Participant
    February 4, 2018

    Thank you so much, that was incredibly helpful!

    Bill Silbert
    Community Expert
    Bill SilbertCommunity Expert
    Community Expert
    February 4, 2018

    Happy to help.

    Terms & ConditionsAccessibility statement
    Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices