Skip to main content
Known Participant
Apr 27, 2025 9:24 PM UTC
Answered

Denoise not completing in version 14.3

When I choose Denoise, and then choose Enhance, I get the progress bar "creating DNG using Denoise" as usual. However, it gets almost to the end, then the photo disappears and I get the message on the gray screen that no photo is selected. I have attempted this several times. My iMac had been powered off/on, and Denoise has worked for me in the past, but this was the first attempt in v.14.3. Ideas?

JohanElzenga
JohanElzengaCorrect answer
Community Expert
Apr 27, 2025 9:30 PM UTC

Check that you do not have an active filter (or are in a smart collection) that filters on raw file type. The incoming denoised file is a linear DNG, which is not a raw file, so a filter like that will not show it.

 

-- Johan W. Elzenga

2 replies

JohanElzenga
Community Expert
JohanElzengaCommunity ExpertCorrect answer
Community Expert
Apr 27, 2025 9:30 PM UTC

Check that you do not have an active filter (or are in a smart collection) that filters on raw file type. The incoming denoised file is a linear DNG, which is not a raw file, so a filter like that will not show it.

 

Translate
-- Johan W. Elzenga
jsopociAuthor
Known Participant
Apr 27, 2025 9:55 PM UTC

Thank you! No filters on, but I was in a collection of all photos from that trip. It was not a smart collection. So, I went to the catalog date folders for those photos and was able to successfully denoise others. 

Translate