Skip to main content
J
jemmd
Participant
October 18, 2019
Question

LR Identity Plate

  • October 18, 2019
  • 2 replies
  • 161 views

On LR Classic I have been unable to move the identity plate from dead center. The boundry box does not appear around the the wording either. Any solutions? I tried unchecking the render on every image as was suggested but if I do that the identity plate completely vanishes. Rebooting does not help.

    This topic has been closed for replies.

    2 replies

    Rob_Cullen
    Community Expert
    Rob_CullenCommunity Expert
    Community Expert
    October 18, 2019

    My experience is this-

    With [Render on every image] is checked- then the IP is fixed (unmoveable) in the centre of the image. (Emphasis on the word "ON" )

    With [Render behind Image] checked- then the IP will dissappear (if it was positioned on the image)

    Try unchecking both these options. I never have these checked and never have a problem moving or re-sizing the IP and the bounding box anywhere on the print page.

    Regards. My System: Windows-11, Lightroom-Classic 15.3, Photoshop 27.5, ACR 18.3, Lightroom 9.3, Lr-iOS 10.4.0, Bridge 16.0.3 .
    J
    jemmdAuthor
    Participant
    October 20, 2019

    Thanks for the advise. Interestingly enough it did not work. That was until I switched my templet. At that point it worked perfectly. So I believe the trickis to turn off  "render" switch templets temporarily and all is fine. Thanks again.

    GoldingD
    GoldingD
    Legend
    October 18, 2019

    Screenshot please. 

    PLEASE USE THE BLUE BUTTON WHEN REPLYING TO POSTS.
    Helps to show posts in date/time order, improves visibility (as not hidden in a reply to a reply), and is easier to use

     

     

     

    Terms & ConditionsAccessibility statement
    Using the community Terms of use Privacy Cookie preferences Do not sell or share my personal information ad choicesAdChoices